جدول دوره های آموزشی

آدرس اموزشگاه

 

Incremental Sheet Forming

Incremental sheet forming (or ISF) is a sheet metal forming technique where a sheet is formed into the final workpiece by a series of small incremental deformations. However, studies have shown that it can be applied to polymer and composite sheets too. Generally, the sheet is formed by a round tipped tool, typically 5 to 20mm in diameter. The tool, which can be attached to a CNC machine, a robot arm or similar, indents into the sheet by about 1 mm and follows a contour for the desired part. It then indents further and draws the next contour for the part into the sheet and continues to do this until the full part is formed. ISF can be divided into variants depending on the number of contact points between tool, sheet and die (in case there is any). The term Single Point Incremental Forming (SPIF) is used when the opposite side of the sheet is supported by a faceplate and Two Point Incremental Forming (TPIF) when a full or partial die is supports the sheet.

Incremental Sheet1

Advantages over conventional sheet metal forming

Because the process can be controlled entirely by CNC processes no die is required as is in traditional sheet metal forming. The elimination of the die in the manufacturing process reduces the cost per piece and increases turnaround time for low production runs because the need to manufacture a die is eliminated. However, for high production run the time and cost to produce a die is absorbed by the higher per piece speed and lower per piece cost. Several authors recognize that the formability of metal materials under the localized deformation imposed by incremental forming is better than in conventional deep drawing. In contrast, there is a loss of accuracy with the ISF process.

Incremental Sheet2

Implemention

The ISF process is generally implemented by clamping a sheet in the XY plane, which is free to move along the Z axis. The tool moves in the XY plane and is coordinated with movements in the Z axis to create the desired part. It is often convenient to retrofit a CNC milling machine to accommodate the process. Spherical, flat-bottomed, and parabolic tool profiles can be used to achieve differing surface finishes and forming limits.

The machine employs a combination of stretch forming by drawing the sheet incrementally down over a die, with the CNC tool approach described above. This is said to produce a more even distribution of thickness of the material. The process is well suited to one off manufacture though difficulties in simulating the process mean that toolpaths are complex and time consuming to determine.

Ford Motor Company has recently released Ford Freeform Fabrication Technology, a two-point incremental sheet forming technique being implemented in the rapid prototyping of automotive parts. Advances in the technology are expected to increase adoption in the near future by other sheet metal-reliant manufacturers.

Incremental Sheet3

Incremental Sheet4

 
       

دوره های اموزشی

شبکه های اجتماعی

                   
    تهران-ضلع غربی مترو نواب-برج سهیل-واحد604  
  
پارس اتوماسیون - پارس اتوماسیون - youtube پارس اتوماسیون - FACEBOOK twiter پارس اتوماسیون - instagram