لیست دوره ها

Drilling Machine

Drilling Machinejpg

 

Drilling

Drilling is a cutting process that uses a drill bit to cut or enlarge a hole of circular cross-section in solid materials. The drill bit is a rotary cutting tool, often multipoint. The bit is pressed against the workpiece and rotated at rates from hundreds to thousands of revolutions per minute. This forces the cutting edge against the workpiece, cutting off chips (swarf) from the hole as it is drilled.

Exceptionally, specially-shaped bits can cut holes of non-circular cross-section; a square cross-section is possible.

Process

Drilled holes are characterized by their sharp edge on the entrance side and the presence of burrs on the exit side (unless they have been removed). Also, the inside of the hole usually has helical feed marks.

Drilling may affect the mechanical properties of the workpiece by creating low residual stresses around the hole opening and a very thin layer of highly stressed and disturbed material on the newly formed surface. This causes the workpiece to become more susceptible to corrosion and crack propagation at the stressed surface. A finish operation may be done to avoid these detrimental conditions.

For fluted drill bits, any chips are removed via the flutes. Chips may form long spirals (undesirable)or small flakes, depending on the material, and process parameters. The type of chips formed can be an indicator of the machinability of the material, with long chips suggesting poor material machinability.

When possible drilled holes should be located perpendicular to the workpiece surface. This minimizes the drill bit's tendency to "walk", that is, to be deflected from the intended center-line of the bore, causing the hole to be misplaced. The higher the length-to-diameter ratio of the drill bit, the greater the tendency to walk. The tendency to walk is also preempted in various other ways, which include:

Establishing a centering mark or feature before drilling, such as by:

Casting, molding, or forging a mark into the workpiece

Center punching

Spot drilling (i.e., center drilling)

Spot facing, which is facing a certain area on a rough casting or forging to establish, essentially, an island of precisely known surface in a sea of imprecisely known surface

Constraining the position of the drill bit using a drill jig with drill bushings

Surface finish produced by drilling may range from 32 to 500 microinches. Finish cuts will generate surfaces near 32 microinches, and roughing will be near 500 microinches.

Cutting fluid is commonly used to cool the drill bit, increase tool life, increase speeds and feeds, increase the surface finish, and aid in ejecting chips. Application of these fluids is usually done by flooding the workpiece with coolant and lubricant or by applying a spray mist.

In deciding which drill(s) to use it is important to consider the task at hand and evaluate which drill would best accomplish the task. There are a variety of drill styles that each serve a different purpose. The subland drill is capable of drilling more than one diameter. The spade drill is used to drill larger hole sizes. The indexable drill is useful in managing chips.

 

SOCIAL NETWORK

                   
    تهران-ضلع غربی مترو نواب-برج سهیل-واحد604  
  
پارس اتوماسیون - پارس اتوماسیون - youtube پارس اتوماسیون - FACEBOOK twiter پارس اتوماسیون - instagram